Multiplexers(Data Selectors) – 2 MCQ’s

Read Time:1 Minute, 40 Second

This set of Digital Circuits Multiple Choice Questions & Answers (MCQs) focuses on “Multiplexers(Data Selectors) – 2″.

1. 4 to 1 MUX would have ____________
a) 1 output
b) 2 outputs
c) 3 outputs
d) 4 outputs

2. A basic multiplexer principle can be demonstrated through the use of a ____________
a) Single-pole relay
b) DPDT switch
c) Rotary switch
d) Linear stepper

3. 4 to 1 MUX would have ____________
a) 2 inputs
b) 3 inputs
c) 4 inputs
d) 5 inputs

4. If enable input is high then the multiplexer is ______________
a) Enable
b) Disable
c) Saturation
d) High Impedance

5. A combinational circuit is one in which the output depends on the ____________
a) Input combination at the time
b) Input combination and the previous output
c) Input combination at that time and the previous input combination
d) Present output and the previous output

6. What is data routing in a multiplexer?
a) It spreads the information to the control unit
b) It can be used to route data from one of several source to destination
c) It is an application of multiplexer
d) It can be used to route data and it is an application of multiplexer

7. The two input MUX would have ____________
a) 1 select line
b) 2 select lines
c) 4 select lines
d) 3 select lines

8. Without any additional circuitry an 8:1 MUX can be used to obtain ____________
a) Some but not all Boolean functions of 3 variables
b) All function of 3 variables but none of 4 variables
c) All functions of 3 variables and some but not all of 4 variables
d) All functions of 4 variables

9. One multiplexer can take the place of ____________
a) Several SSI logic gates
b) Combinational logic circuits
c) Several Ex-NOR gates
d) Several SSI logic gates or combinational logic circuits

10. A combinational circuit that selects one from many inputs are ____________
a) Encoder
b) Decoder
c) Demultiplexer
d) Multiplexer

11. Which of the following circuit can be used as parallel to serial converter?
a) Multiplexer
b) Demultiplexer
c) Decoder
d) Digital counter

12. The inputs/outputs of an analog multiplexer/demultiplexer are ____________
a) Bidirectional
b) Unidirectional
c) Even parity
d) Binary-coded decimal

0 %
0 %
0 %
0 %
0 %
0 %

Average Rating

5 Star
4 Star
3 Star
2 Star
1 Star

Leave a Reply

Your email address will not be published. Required fields are marked *

Previous post Multiplexers(Data Selectors) – 1 MCQ’s
Next post Demultiplexers (Data Distributors) – 1 MCQ’s